Hydra Environment Monitoring System :: Hydra Remote Monitoring

Step 1: Verify all the following components are present:

1 Hydra™ Monitor Panel
1 Power Cord with transformer
1 Water Sensor
1 Humidity Sensor
2 Telephone Cords
1 Surface Telephone Jack
1 Telephone cord Coupler

Step 2: Mount Hydra™ Monitoring Panel
Step 3: Place water sensor(s) Plug sensor into Hydra™ jack labeled #1
Step 4: Install Humidity Sensor within 20’ of Hydra™ Panel and plug sensor into Hydra™ jack labeled #2. (Adjust dial to 50-60%)
Step 5: Install Telephone Jack within 20’ of Hydra™ Panel and Plug Telephone Cord into Jack and other end into Hydra™ jack labeled T.
Step 6: Plug power cord into Hydra™ Panel and plug into a receptacle. The green light on front of Hydra™ Panel should now burn solid.

In order for your Hydra™ Panel to start communication with remote monitoring system you must complete the Registration Form and fax or register online at www.forhydra.com.

After registering your hydra system the system is now in operational. The system will communicate once a month to verify that all systems are working properly, unless there is an alarm condition.

Alarm Condition: Your system notifies our remote monitoring system of any alarm condition and will then notify the installation company or owner of the pending alarm.